The NEXTSTEP/OpenStep FAQ

! to the table of contents
< to the previous section:
> to the next section:


5.13 How do I connect a modem to the NeXT?

modem, on NeXT

Previously, we suggested that people use Mac modem cables; however, it has come to our attention that there is no one standard Mac modem cable.

Since correct modem operation on a NeXT depends upon a correctly wired modem cable, buying a Mac cable is not a good idea. Some Mac cables do not allow dial-in and no Mac cable allows the use of hardware flow control. For these reasons, we are recommending that only cables that meet NeXT specifications be used. [however, if you have a Mac modem cable lying around and don't care about dial-in or hardware flow control, then by all means....]

These cables are available commercially from any store, how still sells NeXT stuff, and from Computer Cables and Devices, or can be custom built. Note that no off- the-shelf Mac cable will allow hardware flow control. It is however possible to make a such a cable from an Imagewriter II cable by replacing one of the mini-8 ends with a DB-25 connector.

Hardware flow control is absolutely essential for all serial port connections with speeds of 9600 bps and above. Make certain that you cable supports it, your modem is configured to use it and you are using the hardware flowcontrol devices /dev/cuf[ab], /dev/ttydf[ab] and /dev/ttyf[ab], respectively.

Most people use tip or kermit to control the modem. SLIP and/or UUCP may also be used (but are more complicated to set up and require the remote machine to also have SLIP and/or UUCP (respectively)).

A version of the DOS-program pcomm can be found on ftp.informatik.uni-muenchen.de

The 2.0 Network and System Administration Manual, which is available in hard-copy (shipped with each machine) contains an extensive description of how to use modems with the NeXT machine. Additionally NeXT in their TechSupportNotes series called SerialPortDoc.wn and UUCP for 1.0/1.0a systems . This document is available from most FTP sites that carry NextAnswers. Also, try to obtain the about.modem.Z file by Mark Adler in the pub/next/lore directory on sonata.cc.purdue.edu



This document was converted from LaTeX using Karl Ewald's latex2html.