Autoconf supports changing the names of programs when installing them.
In order to use these transformations, `configure.in' must call the
macro AC_ARG_PROGRAM.
program_transform_name a sequence of
sed commands for changing the names of installed programs.
If any of the options described below are given to configure,
program names are transformed accordingly. Otherwise, if
AC_CANONICAL_SYSTEM has been called and a `--target' value
is given that differs from the host type (specified with `--host'
or defaulted by config.sub), the target type followed by a dash
is used as a prefix. Otherwise, no program name transformation is done.
Go to the first, previous, next, last section, table of contents.