Go to the first, previous, next, last section, table of contents.
Add `@CFLAGS@', `@CPPFLAGS@', and `@LDFLAGS@' in
your `Makefile.in' files, so they can take advantage of the values
of those variables in the environment when configure is run.
Doing this isn't necessary, but it's a convenience for users.
Also add `@configure_input@' in a comment to each input file for
AC_OUTPUT, so that the output files will contain a comment saying
they were produced by configure. Automatically selecting the
right comment syntax for all the kinds of files that people call
AC_OUTPUT on became too much work.
Add `config.log' and `config.cache' to the list of files you
remove in distclean targets.
If you have the following in `Makefile.in':
prefix = /usr/local exec_prefix = $(prefix)
you must change it to:
prefix = @prefix@ exec_prefix = @exec_prefix@
The old behavior of replacing those variables without `@' characters around them has been removed.
Go to the first, previous, next, last section, table of contents.