Go to the first, previous, next, last section, table of contents.
These macros are used to find declarations not covered by the "particular" test macros.
This macro actually tests whether it is valid to use symbol as an r-value, not if it is really declared, because it is much safer to avoid introducing extra declarations when they are not needed.
HAVE_DECL_symbol (in all capitals) to `1' if
symbol is declared, otherwise to `0'. If
action-if-not-found is given, it is additional shell code to
execute when one of the function declarations is needed, otherwise
action-if-found is executed.
This macro uses an m4 list as first argument:
AC_CHECK_DECLS(strdup) AC_CHECK_DECLS([strlen]) AC_CHECK_DECLS([malloc, realloc, calloc, free])
Unlike the other `AC_CHECK_*S' macros, when a symbol is not
declared, HAVE_DECL_symbol is defined to `0' instead
of leaving HAVE_DECL_symbol undeclared. When you are
sure that the check was performed, use
HAVE_DECL_symbol just like any other result of Autoconf:
#if !HAVE_DECL_SYMBOL extern char *symbol; #endif
If the test may have not been performed, however, because it is safer not to declare a symbol than to use a declaration that conflicts with the system's one, you should use:
#if defined HAVE_DECL_MALLOC && !HAVE_DECL_MALLOC char *malloc (size_t *s); #endif
You fall into the second category only in extreme situations: either your files may be used without being configured, or they are used during the configuration. In most cases the traditional approach is enough.
Go to the first, previous, next, last section, table of contents.