Go to the first, previous, next, last section, table of contents.
If the current directory contains Texinfo source, you must declare it
with the `TEXINFOS' primary. Generally Texinfo files are converted
into info, and thus the info_TEXINFOS macro is most commonly used
here. Note that any Texinfo source file must end in the `.texi' or
`.texinfo' extension.
If the `.texi' file @includes `version.texi', then
that file will be automatically generated. The file `version.texi'
defines three Texinfo macros you can reference: EDITION,
VERSION, and UPDATED. The first two hold the version
number of your package (but are kept separate for clarity); the last is
the date the primary file was last modified. The `version.texi'
support requires the mdate-sh program; this program is supplied
with Automake and automatically included when automake is invoked
with the --add-missing option.
Sometimes an info file actually depends on more than one `.texi'
file. For instance, in GNU Hello, `hello.texi' includes the file
`gpl.texi'. You can tell Automake about these dependencies using
the texi_TEXINFOS variable. Here is how GNU Hello does it:
info_TEXINFOS = hello.texi hello_TEXINFOS = gpl.texi
By default, Automake requires the file `texinfo.tex' to appear in
the same directory as the Texinfo source. However, if you used
AC_CONFIG_AUX_DIR in `configure.in' (see section `Finding `configure' Input' in The Autoconf Manual), then
`texinfo.tex' is looked for there. Automake supplies
`texinfo.tex' if `--add-missing' is given.
If your package has Texinfo files in many directories, you can use the
variable TEXINFO_TEX to tell Automake where to find the canonical
`texinfo.tex' for your package. The value of this variable should
be the relative path from the current `Makefile.am' to
`texinfo.tex':
TEXINFO_TEX = ../doc/texinfo.tex
The option `no-texinfo.tex' can be used to eliminate the
requirement for `texinfo.tex'. Use of the variable
TEXINFO_TEX is preferable, however, because that allows the
dvi target to still work.
Automake generates an install-info target; some people apparently
use this. By default, info pages are installed by `make install'.
This can be prevented via the no-installinfo option.
Go to the first, previous, next, last section, table of contents.