Go to the first, previous, next, last section, table of contents.
This standard option is supported by import
(see section Common command options, for a complete description):
-m message
-
Use message as log information, instead of
invoking an editor.
There are three additional special options.
-b branch
-
Specify a first-level branch other than 1.1.1. Unless
the `-b branch' flag is given, revisions will
always be made to the branch 1.1.1--even if a
vendortag that matches another branch is given!
What happens in that case, is that the tag will be
reset to 1.1.1. Warning: This behavior might change
in the future.
-k subst
-
Indicate the RCS keyword expansion mode desired. This
setting will apply to all files created during the
import, but not to any files that previously existed in
the repository. See section Substitution modes for a
list of valid `-k' settings.
-I name
-
Specify file names that should be ignored during
import. You can use this option repeatedly. To avoid
ignoring any files at all (even those ignored by
default), specify `-I !'.
name can be a file name pattern of the same type
that you can specify in the `.cvsignore' file.
See section Ignoring files via cvsignore.
-W spec
-
Specify file names that should be filtered during
import. You can use this option repeatedly.
spec can be a file name pattern of the same type
that you can specify in the `.cvswrappers'
file. See section The cvswrappers file.
Go to the first, previous, next, last section, table of contents.