update options

These standard options are available with update (see section Common command options, for a complete description of them):

-D date

Use the most recent revision no later than date. This option is sticky, and implies `-P'. See section Sticky tags, for more information on sticky tags/dates.

-f

Only useful with the `-D date' or `-r tag' flags. If no matching revision is found, retrieve the most recent revision (instead of ignoring the file).

-k kflag

Process RCS keywords according to kflag. See co(1). This option is sticky; future updates of this file in this working directory will use the same kflag. The status command can be viewed to see the sticky options. See section status--Display status information on checked out files.

-l

Local; run only in current working directory. See section Recursive behavior.

-P

Prune empty directories.

-p

Pipe files to the standard output.

-R

Operate recursively. This is on by default. See section Recursive behavior.

-r tag

Retrieve revision tag. This option is sticky, and implies `-P'. See section Sticky tags, for more information on sticky tags/dates.

These special options are also available with update.

-A

Reset any sticky tags, dates, or `-k' options. See section Sticky tags, for more information on sticky tags/dates.

-d

Create any directories that exist in the repository if they're missing from the working directory. Normally, update acts only on directories and files that were already enrolled in your working directory. This is useful for updating directories that were created in the repository since the initial checkout; but it has an unfortunate side effect. If you deliberately avoided certain directories in the repository when you created your working directory (either through use of a module name or by listing explicitly the files and directories you wanted on the command line), then updating with `-d' will create those directories, which may not be what you want.

-I name

Ignore files whose names match name (in your working directory) during the update. You can specify `-I' more than once on the command line to specify several files to ignore. Use `-I !' to avoid ignoring any files at all. See section Ignoring files via cvsignore, for other ways to make CVS ignore some files.

-Wspec

Specify file names that should be filtered during update. You can use this option repeatedly. spec can be a file name pattern of the same type that you can specify in the `.cvswrappers' file. See section The cvswrappers file.

-jrevision

With two `-j' options, merge changes from the revision specified with the first `-j' option to the revision specified with the second `j' option, into the working directory. With one `-j' option, merge changes from the ancestor revision to the revision specified with the `-j' option, into the working directory. The ancestor revision is the common ancestor of the revision which the working directory is based on, and the revision specified in the `-j' option. In addition, each -j option can contain an optional date specification which, when used with branches, can limit the chosen revision to one within a specific date. An optional date is specified by adding a colon (:) to the tag: `-jSymbolic_Tag:Date_Specifier'. See section Merging.

Go to the first, previous, next, last section, table of contents.