These Edebug commands let you view aspects of the buffer and window status as they were before entry to Edebug. The outside window configuration is the collection of windows and contents that were in effect outside of Edebug.
edebug-view-outside).
edebug-bounce-point). With a prefix argument n,
pause for n seconds instead.
edebug-where).
If you use this command in a different window displaying the same
buffer, that window will be used instead to display the current
definition in the future.
edebug-toggle-save-windows).
With a prefix argument, W only toggles saving and restoring of
the selected window. To specify a window that is not displaying the
source code buffer, you must use C-x X W from the global keymap.
You can view the outside window configuration with v or just bounce to the point in the current buffer with p, even if it is not normally displayed. After moving point, you may wish to jump back to the stop point with w from a source code buffer.
Each time you use W to turn saving off, Edebug forgets the saved outside window configuration--so that even if you turn saving back on, the current window configuration remains unchanged when you next exit Edebug (by continuing the program). However, the automatic redisplay of `*edebug*' and `*edebug-trace*' may conflict with the buffers you wish to see unless you have enough windows open.
Go to the first, previous, next, last section, table of contents.