Flow Control

This section attempts to answer the question "Why does Emacs use flow-control characters in its command character set?" For a second view on this issue, read the comments on flow control in the `emacs/INSTALL' file from the distribution; for help with Termcap entries and DEC terminal concentrators, see `emacs/etc/TERMS'.

At one time, most terminals did not need flow control, and none used C-s and C-q for flow control. Therefore, the choice of C-s and C-q as command characters for searching and quoting was natural and uncontroversial. With so many commands needing key assignments, of course we assigned meanings to nearly all ASCII control characters.

Later, some terminals were introduced which required these characters for flow control. They were not very good terminals for full-screen editing, so Emacs maintainers ignored them. In later years, flow control with C-s and C-q became widespread among terminals, but by this time it was usually an option. And the majority of Emacs users, who can turn flow control off, did not want to switch to less mnemonic key bindings for the sake of flow control.

So which usage is "right"---Emacs's or that of some terminal and concentrator manufacturers? This question has no simple answer.

One reason why we are reluctant to cater to the problems caused by C-s and C-q is that they are gratuitous. There are other techniques (albeit less common in practice) for flow control that preserve transparency of the character stream. Note also that their use for flow control is not an official standard. Interestingly, on the model 33 teletype with a paper tape punch (around 1970), C-s and C-q were sent by the computer to turn the punch on and off!

As window systems and PC terminal emulators replace character-only terminals, the flow control problem is gradually disappearing. For the mean time, Emacs provides a convenient way of enabling flow control if you want it: call the function enable-flow-control.

Command: enable-flow-control

This function enables use of C-s and C-q for output flow control, and provides the characters C-\ and C-^ as aliases for them using keyboard-translate-table (see section Translating Input Events).

You can use the function enable-flow-control-on in your `.emacs' file to enable flow control automatically on certain terminal types.

Function: enable-flow-control-on &rest termtypes

This function enables flow control, and the aliases C-\ and C-^, if the terminal type is one of termtypes. For example:

(enable-flow-control-on "vt200" "vt300" "vt101" "vt131")

Here is how enable-flow-control does its job:

1. It sets CBREAK mode for terminal input, and tells the operating system to handle flow control, with (set-input-mode nil t).
2. It sets up keyboard-translate-table to translate C-\ and C-^ into C-s and C-q. Except at its very lowest level, Emacs never knows that the characters typed were anything but C-s and C-q, so you can in effect type them as C-\ and C-^ even when they are input for other commands. See section Translating Input Events.

If the terminal is the source of the flow control characters, then once you enable kernel flow control handling, you probably can make do with less padding than normal for that terminal. You can reduce the amount of padding by customizing the Termcap entry. You can also reduce it by setting baud-rate to a smaller value so that Emacs uses a smaller speed when calculating the padding needed. See section Terminal Output.

Go to the first, previous, next, last section, table of contents.