Jumping

The commands described in this section execute until they reach a specified location. All except i make a temporary breakpoint to establish the place to stop, then switch to go mode. Any other breakpoint reached before the intended stop point will also stop execution. See section Breakpoints, for the details on breakpoints.

These commands may fail to work as expected in case of nonlocal exit, because a nonlocal exit can bypass the temporary breakpoint where you expected the program to stop.

h

Proceed to the stop point near where point is (edebug-goto-here).

f

Run the program forward over one expression (edebug-forward-sexp).

o

Run the program until the end of the containing sexp.

i

Step into the function or macro called by the form after point.

The h command proceeds to the stop point near the current location of point, using a temporary breakpoint. See section Breakpoints, for more information about breakpoints.

The f command runs the program forward over one expression. More precisely, it sets a temporary breakpoint at the position that C-M-f would reach, then executes in go mode so that the program will stop at breakpoints.

With a prefix argument n, the temporary breakpoint is placed n sexps beyond point. If the containing list ends before n more elements, then the place to stop is after the containing expression.

Be careful that the position C-M-f finds is a place that the program will really get to; this may not be true in a cond, for example.

The f command does forward-sexp starting at point, rather than at the stop point, for flexibility. If you want to execute one expression from the current stop point, type w first, to move point there, and then type f.

The o command continues "out of" an expression. It places a temporary breakpoint at the end of the sexp containing point. If the containing sexp is a function definition itself, o continues until just before the last sexp in the definition. If that is where you are now, it returns from the function and then stops. In other words, this command does not exit the currently executing function unless you are positioned after the last sexp.

The i command steps into the function or macro called by the list form after point, and stops at its first stop point. Note that the form need not be the one about to be evaluated. But if the form is a function call about to be evaluated, remember to use this command before any of the arguments are evaluated, since otherwise it will be too late.

The i command instruments the function or macro it's supposed to step into, if it isn't instrumented already. This is convenient, but keep in mind that the function or macro remains instrumented unless you explicitly arrange to deinstrument it.

Go to the first, previous, next, last section, table of contents.