Go to the first, previous, next, last section, table of contents.
kill-line).
The simplest kill command is C-k. If given at the beginning of a line, it kills all the text on the line, leaving it blank. When used on a blank line, it kills the whole line including its newline. To kill an entire non-blank line, go to the beginning and type C-k twice.
More generally, C-k kills from point up to the end of the line, unless it is at the end of a line. In that case it kills the newline following point, thus merging the next line into the current one. Spaces and tabs that you can't see at the end of the line are ignored when deciding which case applies, so if point appears to be at the end of the line, you can be sure C-k will kill the newline.
When C-k is given a positive argument, it kills that many lines and the newlines that follow them (however, text on the current line before point is spared). With a negative argument -n, it kills n lines preceding the current line (together with the text on the current line before point). Thus, C-u - 2 C-k at the front of a line kills the two previous lines.
C-k with an argument of zero kills the text before point on the current line.
If the variable kill-whole-line is non-nil, C-k at
the very beginning of a line kills the entire line including the
following newline. This variable is normally nil.
Go to the first, previous, next, last section, table of contents.