Go to the first, previous, next, last section, table of contents.

Query Replace

M-% string RET newstring RET

M-x query-replace RET string RET newstring RET

Replace some occurrences of string with newstring.

C-M-% regexp RET newstring RET

M-x query-replace-regexp RET regexp RET newstring RET

Replace some matches for regexp with newstring.

If you want to change only some of the occurrences of `foo' to `bar', not all of them, then you cannot use an ordinary replace-string. Instead, use M-% (query-replace). This command finds occurrences of `foo' one by one, displays each occurrence and asks you whether to replace it. A numeric argument to query-replace tells it to consider only occurrences that are bounded by word-delimiter characters. This preserves case, just like replace-string, provided case-replace is non-nil, as it normally is.

Aside from querying, query-replace works just like replace-string, and query-replace-regexp works just like replace-regexp. This command is run by C-M-%.

The things you can type when you are shown an occurrence of string or a match for regexp are:

SPC

to replace the occurrence with newstring.

DEL

to skip to the next occurrence without replacing this one.

, (Comma)

to replace this occurrence and display the result. You are then asked for another input character to say what to do next. Since the replacement has already been made, DEL and SPC are equivalent in this situation; both move to the next occurrence. You can type C-r at this point (see below) to alter the replaced text. You can also type C-x u to undo the replacement; this exits the query-replace, so if you want to do further replacement you must use C-x ESC ESC RET to restart (see section Repeating Minibuffer Commands).

RET

to exit without doing any more replacements.

. (Period)

to replace this occurrence and then exit without searching for more occurrences.

!

to replace all remaining occurrences without asking again.

^

to go back to the position of the previous occurrence (or what used to be an occurrence), in case you changed it by mistake. This works by popping the mark ring. Only one ^ in a row is meaningful, because only one previous replacement position is kept during query-replace.

C-r

to enter a recursive editing level, in case the occurrence needs to be edited rather than just replaced with newstring. When you are done, exit the recursive editing level with C-M-c to proceed to the next occurrence. See section Recursive Editing Levels.

C-w

to delete the occurrence, and then enter a recursive editing level as in C-r. Use the recursive edit to insert text to replace the deleted occurrence of string. When done, exit the recursive editing level with C-M-c to proceed to the next occurrence.

C-l

to redisplay the screen. Then you must type another character to specify what to do with this occurrence.

C-h

to display a message summarizing these options. Then you must type another character to specify what to do with this occurrence.

Some other characters are aliases for the ones listed above: y, n and q are equivalent to SPC, DEL and RET.

Aside from this, any other character exits the query-replace, and is then reread as part of a key sequence. Thus, if you type C-k, it exits the query-replace and then kills to end of line.

To restart a query-replace once it is exited, use C-x ESC ESC, which repeats the query-replace because it used the minibuffer to read its arguments. See section Repeating Minibuffer Commands.

See also section Transforming File Names in Dired, for Dired commands to rename, copy, or link files by replacing regexp matches in file names.

Go to the first, previous, next, last section, table of contents.