If you have a system where the IDE CD-ROM is on the second 
          IDE controller, configure the controller from within the 
          UnixWare Device Configuration Utility (DCU) during installation.

          To do this, follow the installation until you are prompted to 
          "Install Host Bus Adapter Drivers".  Install any HBAs that your 
          system requires, including TF2228.  Continue the installation 
          until you see:

                (*) Continue Installation
                ( ) Enter The DCU (See CAUTION Above)

          Use the arrow keys to position the asterisk (*) beside the 
          DCU option and press <Enter>.

          Select "Software Device Drivers" from the DCU Main Menu.

          Select "Host Bus Adapters" form the Software Device Driver
          Selections Menu.

          Use the <PgDn> key to scroll through the HBA Driver list
          until the ide driver is displayed. 

          Use the arrow keys to position the cursor on the ide 
          selection.

          Press <F5> to display the "New Hardware Configuration" screen.

          Press <F10> to accept the values that are displayed.

          Press <F5> once again to display the "New Hardware Configuration"
          screen.

          Set the Unit number to 1.

          Use the <Tab> key to move the cursor to the IRQ field and change 
          the value to 15.

          Use the <Tab> key to move to the IOStart field and change the 
          value to 170.

          Use the <Tab> key to move to the IOEnd field and change the
          value to 17f.

          Use the <Tab> key to move to the MemStart field and change the
          value to 0.

          Use the <Tab> key to move to the MemEnd field and change the
          value to 0.

          Press <F10> to apply the changes. The second controller is now 
          configured.

          Press <Enter> to return to the "Software Device Drivers Selection"
          menu.

          Select the "Return to DCU Main Menu" entry and press <Enter>.

          Select "Apply Changes & Exit DCU" from the Main Menu and press
          <Enter>.

          The installation should now continue by loading the hardware
          drivers. You will then see a "Select Installation Method" menu 
          that includes these options:

                Install from CD-ROM
                Install from TCP Network Server
                Install from SPX Network Server
                Cancel Installation and Shut Down System

          You can now select CD-ROM as the installation media and 
          proceed with the installation.